HPM TILEBOND C2

HPM TileBond C2, new name TileBond 300 Pro, is an improved, one-component cement-based high-quality tile adhesive. The adhesive is produced from Portland cement, selected mineral aggregates and special polymer additives at HPM's factory in Phu Tho, according to TCVN 7899-1:2008.

This is a line of adhesives for large format tiles, heavy bricks and locations that need to be highly bonded, which can be used both interior and exterior.

Key features

• High adhesion: adhesion strength at standard conditions from 1.2 MPa; after immersion, after heating and after thawing is 1 MPa or more.
• Anti-slip: firmly hold large format tiles, heavy bricks on vertical walls.
• Moisture resistance: limits water penetration into the tile, can be used for wet areas and swimming pools.
• Weather resistant: subject to the effects of humidity and temperature changes in outdoor areas.
• Long opening time: from 30 minutes, enough time to align large format tiles.

• Materials: ceramic tiles, porcelain, granite, natural stone, especially large format tiles.
• Works: civil houses (apartments, villas), commercial works, factories and technical infrastructure items.
• Furniture: living room floor and wall, bedroom, kitchen, toilet.
• Exterior: covered area and outdoor area.
• Surface: dry floor and cement wall.

Maximum Tile Size by Location

Dry interior tiles with medium-sized tiles, you can consider C1 HPM TileBond tile adhesive.

Data according to product technical documentation, measured under laboratory conditions. Actual results may differ depending on the conditions and method of construction at the site.

Construction Information

• Mixing ratio: glue and water in a ratio of 1: 0.20 to 0.24 by weight, equivalent to about 5 to 6 liters of clean water for 1 bag of 25 kg.
• Consumption norm: 3.5 to 5.0 kg/m², depending on the size of the tiles and the roughness of the substrate.
• Shelf life after mixing: about 30 to 45 minutes (at 27°C, 65% humidity).
• Construction surface temperature: from 12°C to 40°C.
• Standby time: grout the walls after 7 to 8 hours, the floor after 24 hours; put into use after 14 days.

Step 1: Surface Preparation

The surface must be solid, clean, flat, free of dust, grease or impurities that reduce adhesion. Strongly absorbing water needs to be moistened first but not allowed to stagnate.

Step 2: Mix the glue

Put the quantified amount of water into the container, slowly pour in the glue and stir well. It is recommended to use a hand whisk or a low-speed mixer to make the glue homogeneous.

Step 3: Tiling

Use a serrated trowel to plaster the glue on the base, keep the plane at an angle of about 60 degrees so that the glue groove is even. For large tiles, a thin layer of glue should be applied to the back of the tile (double cladding), place the tiles and lightly tap with a rubber hammer to spread the glue evenly.

Step 4: Cleaning

Wipe off any excess glue with a damp sponge before the glue dries completely.

Storage and safety

Keep in a dry place, put on a pallet, keep the bag tight. The shelf life is 6 months from the date of manufacture. The glue contains cement, it is recommended to wear gloves and glasses when applying, avoid letting the wet glue stick to the skin for a long time.